07/09/2023 Updated: Mileage not showing on the dashboard is a common problem experienced by car owners. It can range from inconvenient to dangerous, as it can lead to inaccurate readings for important functions such as fuel consumption and oil changes. Plug DigiProg to your car. (Contains over 40 different cables, which guarantees compatibility with nearly ever car model in the world. Only requirement is car must be made AFTER 1996, and car model must be supported). Go to "Odometer Change" screen inside DigiProg. Enter new mileage number and upload new data to car at push of a button. To reset flashing mileage, turn the car key to the “on” position. Locate and press and hold down the odometer reset button until you see “trip” appear in your dash display. Keep pressing until all of the dashboard lights blank out except for “trip,” then release it. Next, use a small flathead screwdriver to push up on either side of I havent looked at many, infact only 2 but it could be a dry joint where the actual moving coil speedo attaches (pushed through) the pcb. As for the mileage . join the club Working on a solution to the problem as mine (and no doubt yours if not as simple as a blown bulb) is the ribbon cable that attaches the lcd module to the pcb. It may be OK if the timing is only 2 teeth out. and only then will you know if you got away with it. It deffo wont start if its 2 teeth out as the valves are not closing to allow compression to develop. It may not even have bent a valve but you won't know until you get a good mech on the job. If the valves are shagged get a recon head or a head Just got myself a scudo van 51 plate my front door lock does not work , I have read about the locks just keep turning but my one i can't turn the key at all , is there anyone that knows how to fix this problem and also my mileage counter is blank , how do you fix this HELP Does anyone have any idea why the Horn in my 2008 Scudo doesn't work? I have removed and checked the horn itself and works ok on the bench. The two wires connected to it seem ok, green is ground and continuity test shows its good and the red has a constant 10.47 volts with the ignition switched Get a replacement radar of the manufacturer’s brand name. Unplug the old backup sensor from the back of the bumper. Take off the destroyed parking sensor from your Fiat Scudo, this step is very intuitive, it is only clipped on. Remount the new sensor and connect it. All you’ll have to do is test it to make sure it’s operating effectively. bLpuw.

fiat scudo mileage display not working